8MM FORUM WORLDWIDE https://www.8mmforumworldwide.com/ |
|
Can someone offer projector repair advice https://www.8mmforumworldwide.com/viewtopic.php?f=8&t=100 |
Page 1 of 1 |
Author: | Matthew Walls [ Sat Jul 09, 2011 6:41 pm ] |
Post subject: | Can someone offer projector repair advice |
I recently bought an ELMO ST 600 Super 8 projector on Craigslist. I ot it opened today. It runs (motor sounds good) but nothing would turn. The drive belt is broken and the take-up arm below is broken. This is more repair work than I believe I am capable of. Is there someone I can send the projector to that could fix it? Any idea how much it would cost to have this work done? Thanks everyone, Matthew |
Author: | Dan Lail [ Sat Jul 09, 2011 10:03 pm ] |
Post subject: | Re: Can someone offer projector repair advice |
Matthew, can you post some pictures of the inside and outside of the projector? Richard Patchett repairs projectors. If you click the Film/Equipment button at the top of the page, his info is on there. |
Author: | Matthew Walls [ Sun Jul 10, 2011 12:36 pm ] | ||||
Post subject: | Re: Can someone offer projector repair advice | ||||
Dan, Thanks for the reply. I clicked the link and will get in touch with Richard. Here are some pictures of the inside. Thanks, Matthew
|
Author: | Dan Lail [ Sun Jul 10, 2011 4:56 pm ] |
Post subject: | Re: Can someone offer projector repair advice |
Have check all fuses? |
Author: | Richard C Patchett [ Sun Jul 10, 2011 7:18 pm ] |
Post subject: | Re: Can someone offer projector repair advice |
Greetings Matt You say the take-up arm below is broken but you did not show a picture of it I Have the belts in stock just have to find them may have a used arm in stock or part of it Thank you Dan for the referral RC |
Author: | Jon Addams [ Thu Aug 11, 2011 2:20 pm ] |
Post subject: | Re: Can someone offer projector repair advice |
Hello Richard, I have a couple of arms for that projector and I also have other Elmo parts. Please let me know if you receive the projector for repair and need the arm. Regards Jon |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |