| 8MM FORUM WORLDWIDE https://www.8mmforumworldwide.com/ |
|
| MovieStuff Workprinter Trouble https://www.8mmforumworldwide.com/viewtopic.php?f=8&t=2003 |
Page 1 of 1 |
| Author: | Anaïsa Visser [ Thu Sep 10, 2015 7:54 pm ] |
| Post subject: | MovieStuff Workprinter Trouble |
Hi all, We have a MovieStuff Workprinter set up to transfer regular 8mm and super 8mm to digital, using Velocity as the software. I'm getting some serious vertical pulldown artifacting - I've uploaded a short video here https://youtu.be/NbOvsnrAI6E I've tried adjusting the timing ring a millimeter at a time and was unsuccessful. Any other advice? Thanks! |
|
| Author: | Tom Fales [ Fri Apr 23, 2021 7:44 pm ] |
| Post subject: | Re: MovieStuff Workprinter Trouble |
You're having a sync problem. Use "Manual" sync and try it at -15.00 setting on a short clip. Don't need to recapture, just re-process. Continue to try different settings until problem goes away. Odd, but I found the higher settings adjust smaller pulldown issues better than lower settings. You've probably already solved this, but wanted to pass on my experience (I have two Workprinter-HD units that I converted to work with direct capture from projector lens). Tom |
|
| Author: | Tom Fales [ Fri Apr 23, 2021 7:46 pm ] |
| Post subject: | Re: MovieStuff Workprinter Trouble |
Upon looking at the video in question more closely, a smaller manual sync adjustment may be better to start, say -2.00 or +2.00 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|