| 8MM FORUM WORLDWIDE https://www.8mmforumworldwide.com/ |
|
| How do you install 2 blade shutter on ELMO GS 800? https://www.8mmforumworldwide.com/viewtopic.php?f=8&t=2500 |
Page 1 of 1 |
| Author: | Roger Cathey [ Mon Jan 21, 2019 6:47 pm ] |
| Post subject: | How do you install 2 blade shutter on ELMO GS 800? |
I have seen on the forum how to install a 2 blade shutter on the GS 1200 but how much difference is there in doing the GS 800? |
|
| Author: | Leon Norris [ Tue Jan 22, 2019 1:57 pm ] |
| Post subject: | Re: How do you install 2 blade shutter on ELMO GS 800? |
Hi Roger, to install a two blade shutter on a GS800 should be the same as the GS1200. It might be a little Easter . the shutters you can get from the reel image! They have them in stock Brand new. Price 35.00. Good luck! Leon. |
|
| Author: | Roger Cathey [ Tue Jan 22, 2019 2:48 pm ] |
| Post subject: | Re: How do you install 2 blade shutter on ELMO GS 800? |
Thanks Leon. I thought that since the 800 had fewer parts inside than the 1200 that it might be a bit easier. I was wondering about setting the shutter timing and how to accomplish this. |
|
| Author: | Leon Norris [ Tue Jan 22, 2019 4:21 pm ] |
| Post subject: | Re: How do you install 2 blade shutter on ELMO GS 800? |
Roger, It might take a few trys to get it right . to set the shutter! Once you get it . then you tight in up the screw's. On the shutter! All so you can adjust the lamp. For more light. And take the lamp wire and solder to the high side on the transformer. You see the lamp wire is usely on the low setting! From the factory! Leon. |
|
| Author: | Roger Cathey [ Wed Jan 23, 2019 10:26 am ] |
| Post subject: | Re: How do you install 2 blade shutter on ELMO GS 800? |
Thanks for the information. |
|
| Author: | Roger Cathey [ Fri Jan 25, 2019 1:01 pm ] |
| Post subject: | Re: How do you install 2 blade shutter on ELMO GS 800? |
Leon. The GS 800 doesn't have a HI LO lamp switch. Is it still possible to wire the 100w lamp for more light? |
|
| Author: | Leon Norris [ Fri Jan 25, 2019 3:23 pm ] |
| Post subject: | Re: How do you install 2 blade shutter on ELMO GS 800? |
Hi Roger, It should be on the transformer. I know the ST800 did not have a lamp switchh! Usely the ones that don't have the hi lo lamp switch. You have to move the lamp wire to the hi or lo terminals!on the transformer! So try that out. Leon |
|
| Author: | Leon Norris [ Tue Jan 29, 2019 3:46 pm ] |
| Post subject: | Re: How do you install 2 blade shutter on ELMO GS 800? |
Hi Roger, what Elmo machine are you using now! You to have different ones ? What ever happen to your GS1200? Well let me know what's up! Take care! Leon. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|