| 8MM FORUM WORLDWIDE https://www.8mmforumworldwide.com/ |
|
| Problem with my elmo GS1200 https://www.8mmforumworldwide.com/viewtopic.php?f=8&t=2663 |
Page 1 of 1 |
| Author: | Les Pivnic [ Thu Mar 04, 2021 3:39 pm ] |
| Post subject: | Problem with my elmo GS1200 |
My GS1200 has developed a problem when sceening a film. The projected image "judders" for lack of a better word, on the screen. The projected image does not remain steady on the screen. Can anybody suggest what might be the problem and how I can attempt to fix it. Here in Sydney, there are no longer any repair facilities for movie projectors. Any help will be greatly appreciated. |
|
| Author: | Dan Lail [ Fri Mar 05, 2021 1:34 am ] |
| Post subject: | Re: Problem with my elmo GS1200 |
Hi Les, inside the The back cover plate there is a small Motor control circuit board maybe one and 1/2“ x 1“. If you can find a new motor control board this will probably resolve the problem. If you can find one they are easy to replace remove a couple of screws and a small multiplug, then install the new one. |
|
| Author: | Les Pivnic [ Fri Mar 05, 2021 3:42 am ] |
| Post subject: | Re: Problem with my elmo GS1200 |
Thanks Dan for the suggestion. Finding a replacement will not be easy but I will give it a go. Thanks again! Les |
|
| Author: | Les Pivnic [ Mon Mar 08, 2021 8:47 pm ] |
| Post subject: | Re: Problem with my elmo GS1200 |
Hi again Dan, With regard to my GS1200 problem, you mentioned that it might be the "motor control circuit board". Would you possibly have a photo or diagram of the item that I could use to look for a replacement? It is almost impossible to look for the item when I don't know what it looks like. I opened the back of my GS1200 and I don't even know what I'm looking for? Van Eck Video Services might have the part that I need - so a photo would help me. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|