8MM FORUM WORLDWIDE https://www.8mmforumworldwide.com/ |
|
Projector Repair Weekend https://www.8mmforumworldwide.com/viewtopic.php?f=7&t=2646 |
Page 1 of 1 |
Author: | Chris Smith [ Tue Sep 08, 2020 5:13 am ] |
Post subject: | Projector Repair Weekend |
Spent part of a very relaxing long weekend working on a few projectors which were collecting dust. New belts installed on three Elmo ST-1200s. One of the three machines had corroded/ rusted clutch pulley wheels (!) but fortunately I had a replacement in my parts graveyard. All three are now running nicely. Next I did an easy focus knob restore on an Eiki. I used clear plastic aquarium tubing on the spindle. Finally, I installed new rollers on one of my Ektagraphics (16CL). The original rollers on these machines become goo, so it was an easy, and necessary, half hour job to install a new set. My second CL is waiting for a roller set to be delivered. Fun time was had by all. |
Author: | Ken Layton [ Tue Sep 08, 2020 12:42 pm ] |
Post subject: | Re: Projector Repair Weekend |
For those rusted pulleys, soak them overnight in Evapo-Rust. It should clean them up nicely. You can buy Evapo-Rust at O'Reilly's Auto Parts, Auto Zone, and Harbor Freight Tools. O'Reilly's has it in both the quart ($8.00) and the gallon ($26.00) jugs. Everyone else sells it in the gallon jugs. |
Author: | Chris Smith [ Tue Sep 08, 2020 4:19 pm ] |
Post subject: | Re: Projector Repair Weekend |
Thanks for the tip, Ken. I'm passing a Harbor Freight tomorrow |
Author: | Robert Crewdson [ Mon Sep 14, 2020 6:39 am ] |
Post subject: | Re: Projector Repair Weekend |
Well done Chris; my plan next month is to get a spare 16mm serviced, upgraded to modern lamps, and a new worm gear, then I should be set up for life. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |