|
Film Expert |
Joined: Sat Apr 29, 2017 8:03 am Posts: 4 Location: Burnaby, B.C. Canada
|
I installed a new capacitor to replace the original C172 in my GS1200. As careful as I was it looks like I have created 2 solder bridges. Looking at the back of the board, where the top cap terminal is, solder is touching the terminal to it's right. These two points appear to be part of one printed circuit but need advice. The same thing happened at the bottom terminal. solder is touching the terminal beside it to the right. These terminals appear to be part of another printed circuit. I would appreciate advice on this.
|
|