I have a Eumig Mark S 712D I am trying to get the drive wheel adjusted between the for. and rev, drive wheels. I can get it to where both fwd and rew work but you have to jiggle the selector switch on the front of projector. I want it so you just put it in forwad and it goes also the same in rewind. When I got this both adjusting screws were missing on either side of the motor. I have also adjusted to 2 screws that hole the motor in place. They allow adjustment for tilt toward front of back of unit. The 2 side screws adj. pressure against either rubber wheel. A really tough mechanism to get right. Andbody got any suggestions?
UPDATE 8/02
I figured out the problem. I refabricated the nylon bushing that the motor mount goes in. It had completely detieriorated to pieces over time. I used epoxy to make another one. I had to remove the motor to do the one on the inside near the casing. Now to let it set then reassemble.
The screw in the pic is just to keep epoxy out of the bushing.
| Attachments: |
|
mount 026.JPG [ 142.96 KiB | Viewed 2331 times ] |
|
mount 024.JPG [ 135.67 KiB | Viewed 2331 times ] |
|
projector 023.JPG [ 152.6 KiB | Viewed 2341 times ] |