|
Film Expert |
|
Joined: Sun Jun 05, 2011 4:45 am Posts: 161 Location: Hillside, N.J.
|
Does anyone have a Eumig 807D, 810D or a non dual 8 machine for parts? Possibly and 802 would help.
There's one particular part I am looking for. I don't have a name for it since I don't have a service manual.
When the rear cover is removed, the spindle assembly that leans toward FWD and REV rubber pads sits in front of a small stabilizer block; almost resembling a pad lock (square on bottom and round atop) with three holes for screws to mount. That's the part I need. It should have a yellow plastic non removable washer inside. That's the MOST important part and the reason why I need this (the yellow washer cracked and thus rendered that area useless). The two screws should have gray, dried latex (which means Eumig didn't want anyone removing it them; but can be removed with a fine screw driver and some WD40, if need). I have a pic of the part that is useless but could display so one can compare. Thanks for any help in locating.
John
|
|